Thanks Brady - It does look like the power supply went out. The buddy is a little less than a year old so I'm a bit surprised (but it is just a simple ATX supply). One the main ATX plug - I don't...
Type: Posts; User: sheridan
Thanks Brady - It does look like the power supply went out. The buddy is a little less than a year old so I'm a bit surprised (but it is just a simple ATX supply). One the main ATX plug - I don't...
I have a buddy 32 standard. When I went to turn it on this morning, there was a problem. The drives locked up but the prox leds did not light up and the control software would not find the buddy. ...
Yes! I (actually Mike) figured it out. I was replacing the fuses and going over everything, again for the fourth time
and found it. One of the wires on the transformer out to the board was...
This is a standard so it just has the plain box with a switch on it. I don't think it's a heavy duty relay.
Much beyond checking the voltage on something like this and I'm getting out of my...
I tried updating the firmware and it didn't make a difference. Still won't move.
Mike, That is something I didn't think of. I checked and I'm getting 65v out of the transformer and the same running into the board so it doesn't seem like that is the problem. I'm guessing that it...
Thanks Jack but I already tried that. I unplugged it, waited a few minutes and still have the problem.
Phil
I just went out to run a file and I'm having some problems. I turned on the buddy and the software picked it up, but it wont move. I've re-booted everything several times. The control box seems to...
I tried just cutting my own T-Tracks directly in the mdf but ran into a problem. When the clamp (the shopfox ones like Steve used) tightens down, it pulls up a slight bit and can pull the material...
There is very little info out there on Crystalac (and they don't have a web page), but it is pretty much the same as Target USL - http://www.targetcoatings.com/oxford-spray-lacquer.html
I did...
I've got some that might work for you. Crystlac super premium or Target USL. I've used both and they are great. I think I remember that they could either use heat or UV to speed the cure times -...