First official project turned into an EPIC FAIL. I am having problems with the shopbot, I designed an address plaque on artcam and when I went to cut it the numbers were mirrored. What was...
Type: Posts; User: zfisher
First official project turned into an EPIC FAIL. I am having problems with the shopbot, I designed an address plaque on artcam and when I went to cut it the numbers were mirrored. What was...
important info i forgot...ran the screws from the bottom up...
Glued and clamped the mdf today with wood glue. Clamped the heck out of the outer perimeter then I drilled and countersunk holes in the middle and ran screws to pull the top sheet down. I'll remove...
Finally got the 1st sheet of MDF mounted and ready to glue on the top sheet. What is every ones thoughts on possibly using contact cement. Or should I stick with some classic Elmers wood glue?
...
Thanks for the help, I finally got the proxy switches and the z zero wired up. For some reason input 1 would not work in the control box put zero on input 5 and it works fine. Thanks for all the...
Finally figured out the proximity switches... the manual was wayyyyyy off!.. I wired up the z zero and went to C2 command to check if it was working and of course it is not. The wiring in the...
I am having some problems getting my proximity switches to work. When i go to run the Shopbot Prox Switch setup the machine will run itself into the stop blocks and grind the Sh*t out of the gears...
Setup my new PRS Standard shopbot the past few days and I am down to the wiring through the e-chain and wiring setup in the control box. I'm not real fond of the instructions on how to run the...
In response to Bob Condon's post........
(Because these kids are the future for Shopbot, maybe Ted can help you out to get to that 4x8 size bed for that 4x4 price? These kids, in the future, are...
Thank you all for the info and hopefully more to come!!
I was going to go with the spindle because only safety glass and my classroom will separate us. Judging from the porter cable router on a...
I am a teacher at a high school in Pittsburgh, Pa and I have been searching for various CNC routers to incorporate into my Automation curriculum. My superintendent came to me today and said we have...