I have a 2013 YASKAWA V1000 30 amp and a 4hp hsd spindle
For $500 + shipping
Type: Posts; User: Joseph clements
I have a 2013 YASKAWA V1000 30 amp and a 4hp hsd spindle
For $500 + shipping
Where did you buy The gear reduction and electronics?
We're did you get the art file and the mudshake?
What was the cost on the gear reduction and the electronics?
Try this
http://www.bangleguy.com/page/page/8464584.htm
Like to try a Topographic Map of the moon
Replacement spine for my bad back
Dick when I start the warmup file it starts at 9000 rpm, how can I make it go lower?
It's a 4hp hsd
What I should have said, is it will only go down to 9000 rpm
Pierre said his will go down to 500 rpm for drilling
Check the USB connection for the VFD
What spindle do you have? My 4hp will only go to 9000 rpm
I used Onsurd bits. And don't have this problem
I have so copper. Any thing on what bit and feed, speed to do
When my alph did that. I flip the Breaker in the panel on my house to cut off power, then back on. And it reset it. It's worth a try
( when you turn off the shopbot on the machine the...
I don't know if it will help. Try to cut the power off at the breaker panel, and back on It will reset the controllers memory
Yes I have masonic files email me ted-clements@sbcglobal.net
The candle has a magnet under the veneer so it dose not fall off it burns oil
Yes I buy from M&G saw mill. A clock from them. Thanks for the eBay tip
What software do you use? And would you post files. I live in Houston Texas, I do work with Mesquite.
Walnut book
We're do you get your fonts?
TG ! your like leonardo da Vinci, your every word is a stroke of genius.
I follow your work so I may better my work,
Thanks
TG I was looking at your site, I like the BUTTER KNIFE but there is no image
Of what I get for $10. Is it a 3d file? or a wood butter knife.
Has anyone set this up on a shopbot yet? If so I could use some tips on
The configuration option in software. And a jig for shopbot table I have a 4x8
Now that's a button