Search:

Hey Richard, I'm in Toronto and have been using the MDF sold at The Home Depot, it is different than the stuff from Commonwealth. I have a 4X8 bot and cut cabinet parts using a single fein for vacuum...

Well hooked her up today and ran it, seems to be okay, sounded a bit different (smoother) but it could be the new space. The spindle felt lukewarm after the warm up routine but I wouldn't know if...

Dave, first let me thank you for your reply. I did have an electrician there (supplied by the landlord) that I was leery of, in my unit he gave me a a 12 /3 wire red, black, white and ground at the...

Dana, 3 phase would be great if I had a 3 phase spindle but I have a single phase 2.2hp HSD spindle and the VFD that came with it (from Shopbot). I am in no mood to replace it and am looking for the...

Frank the spindle wants 220 volts +or- 10% the VFD is asking for 230 volts we tested the the 2 legs and it is 210 volts. Is this good enough or do I need a transformer, also how much does one of...

Gary I have a HSD spindle and a Yaskawa VFD which came with my PRS. I ordered the single phase unit because at the time I was using the Bot in a garage with normal house current. The spindle is rated...

Just moved to a new shop that has 3phase power,but own a single phase spindle what do I have to do to get it running.

I sort out my zipper noise problem by making some adjustments to my motor drivers. the geckos have a trim pot on them and there are instructions in the manual which can be downloaded at the Gecko...

You can try to adjust the driver. There is a adjustment pot on the gecko drivers. First set the move speed very low then turn the adjustment screw until it is quiet as possible. There is a better...

I just swapped the control board and drivers on my PRS Standard to sort out some issues I was having but now I hear zipper type noise when an axis starts and stops. Is what I am hear ramping noises. ...

German Ted sent me a new control board and drivers and that solved my specific problem. Hope this helps.

David

!!!!! PROBLEM SOLVED !!!!

I would like to thank everyone at ShopBot especially Ted for the help in getting my problem solved. I'm very happy to know that I have bought a product from a company...

Ted thanks for jumping in. I'd say that it is just the x axis and it occurs on both straight and diagonal moves, in jog and move mode. This situation has eaten up hours upon hours of my time and ...

Mike, I think you may have misunderstood me. The problem is only at SV's 5 and 6 while SV's of 7 and up are fine and 4 and down are fine. Also the noise does not happen the full length of the x rails...

Mike I have the black G202 drivers and for motors I have Orientals and for the number I'm not sure at the moment. I,ll guess and say A7421 943ktg??? And by the way Mike I appreciate you taking the...

By the way guys,I'm running a Standard not an Alfa at 120v and a spindle at 220v. Brady I have run the test and the result is over 80% as stated in my original post, but if you think that this is...

I just got a new PRS Standard about 5 weeks ago. I am having a problem that I am hoping someone here can help me with. I have explored pretty much anywhere that a problem might occur and I can tell...