Search:

Thanks,i got thru with Edrawings.

Good day everyone,how can i open an easm?

Hello everyone,bot is working again as it should,did get some help from shotbot tech,my vu settings were off for the x and y,ran a cut file to just to make sure,time to do this indexing of the...

Further update,i have to reset the vu setting for the shopbot,tech support says that they should be 509.2956 for the type of stepper motor on the shopbot,by doing that the position of x and y have...

it is running but now seem to have lose the sizing on the sheet,4' by 8',the file i am running,after doing the first cut it has move off the sheet to be cut.I stopped the it and did a JH,took the y...

Back up and running again,i reinstall the software about to cut some dovetails for two boxes i want to store some plugs in.

Have sent an email to ShopBot Tech Support,the ShopBot is PRT model running 3.4x software control version.An other question what post processor should i used to do a fluted job.

Help to all,have an issue with the bot.i have some spindles to cut,i was going along good,doing the wraping,the toolpathing ,however,went told to change the axis from 3 to 5, i am now getting two...

Ok i realized that i didn't off set to the correct distance as well setting the correct angle of 60 degree.

Ok I think i got it sorted out now,will do a run and posted back in a few.

Hello to all,i am need of some help again,so far was able to do a few drawings without any assistance,however now the company has being asked to build lattice for some doors.I have attempted to do...

Scottp55,you are correct,click on the 'n' to go to node editing and they was alot,have edited and ran an other cut file,much better,thanks.

See picture of the a small section.29983

Here is the info for the cutter :

Using a 1/4" up-cut spiral,pass depth is 0.125" ,step over is 0.105"@ 42.0%, spindle speed is 12000, feed rate is 100 and plunge is 30 "/min.Here looking to queak...

Found the problem,it had jump off the rollers,the dust extractor as it came down to do the second cut was hitting a hold down clamp,will re-cut and posted picture,thanks.

Good day to everyone,want to thank Rob for his help in getting a decent vector to work with,however i said i would do a section of the work to shown the client,ran a preview of the toolpath,yet to my...

Yes i am in the deep end concerning this project,watching as many tutorials as i can,to get my head around working with ShopBot,just got some new cutters as well,1/4" spiral-up and 1/8" ball...

Sir in my haste to show that i am making progress,i understand that toolpath isn't showing what i wanted in the first picture,but i was getting difficulty in actually producing the toolpath show,i am...

29902Here is just a preview of the toolpaths.

Yes i know,but the picture i was working shows different ,going to do a tracing layout on Wednesday of the picture i sent, since the pictures being sent by the customer is of poor quality.See the...

Hello to all,sorry about not getting back to those who chime in with help, i was cutting the router bit holders for the guys in the shop,i did do it as was instructed and it work,the attached picture...

Good day to all,this here is my first posted since i am now getting my teeth into the world of ShopBot,just a question to the more season people here.i have being asked to do 12 of the picture...