Search:

Slowing it down to 60 ipm helped quite a bit. I'll try slowing it down further. Most of those ridges along the center of the letters are intact, but some still rip out a bit.

31779

Thanks for the help!
I can't seem to post a picture that's any larger than what's in the OP. I'll just list the settings then.

Diameter: 1.25 in
Included Angle: 90.0 deg
Pass Depth: 0.5 in...

Hi,

I'm just getting started using my new (to me) ShopBot. I've made a nice vacuum jig to hold down boards while I machine them and that works well. I have a Porter Cable router which I bought...

Thanks for the advice everyone! Thanks particularly for the specific grounding advice. I think I would like to do all that irrespective of this issue - good insurance.

Update: Tom from ShopBot...

Thanks for the replies.

As for the Raspberry Pi, that was just me ranting. I'm not expecting that to be an option but I've built some 3D printers that run off an Arduino just fine so I know it's...

Hi,

I'm about at my wits end trying to solve a communication error.

I bought a (lightly) used PRS 4896 recently and it has suffered from USB connectivity errors since I got it. I have tried:
...