Hi Erik, thanks for answer. I have to work on an oval panel. my customer needs carving border on it. The pattern he chooses is a flower-mantel. It's my first oval project, please I want help to...
Type: Posts; User: hykambois
Hi Erik, thanks for answer. I have to work on an oval panel. my customer needs carving border on it. The pattern he chooses is a flower-mantel. It's my first oval project, please I want help to...
please I need some advices, my question is: how can I insert and adjust an horizontal mantel(ornaments) as a border in an oval shaped project. thanks for suggestions.
please I need help for an oval project. My question is: how can I insert and adjust as a border, an horizontal mantel in my oval shaped project. thanks for good suggestions.
please, my question is: how can I insert and adjust an horizontal mantel as border in an oval shaped project. thanks for help.
Hi Ken. Thank you for answer.. I have a PRSSTANDARD 96x48 and currently the Z unit values is on (1). last week I've had a bad expérience when I tried moving with these parameters: As I pushed "OK" it...
I am new with shopbot and I try to start with this tool for the first time. As recommended I zero'd the three axis,then with proportion (1) moving was wrong: it jumped up. When I reduced Z to(-1)it...
I am new with shopbot and can't yet move it. I need much help from you because I am far from U.S.A and try to start my tool by myself only with your advices and recommendations via this forum.
As...
I created a project in partworks and saved it. now, I need to link and upload this job to my shopbot. Any help will be appreciated . Thanks
I am programming my yaskawa and I cannot set the value "100" for the parameter "N024" concerning the Preset Frequency, as shown in the yaskawa drive settings manual. the result is always "18"...
I just got my PRSSTANDARD and I have a big problem with running USB cable between VFD, Control Board and computer. I've followed all Assembly Instructions but have difficulties to understand how to...