@tlempicke: Ugh.... I'm getting the "moan and groan" again on my DT (THK bearings). Last time this manifested itself as jittery behavior while doing small-ish circles (under an inch in diameter --...
Type: Posts; User: CNCDave
@tlempicke: Ugh.... I'm getting the "moan and groan" again on my DT (THK bearings). Last time this manifested itself as jittery behavior while doing small-ish circles (under an inch in diameter --...
I've been mucking about in MTC.SBP to display status information and I'm finding the PRINT command to be pretty, uh.... "quirky".
Setup:
Using VCarve Pro with my ShopBot Desktop
In...
To set the stage: I'm old. I forget stuff. My auto-tool changer is me.
To help me remember, I've been mucking about in MTC.SBP to display status information and I'm finding the PRINT command to...
Did you ever get this to work? I'm running into the same problem and have tried every variation I can think of to slip a CRLF into the string I display.
Check your bearings on each axis. I had an issue with my 2012 Desktop (circles in particular) and found that one of the y-axis bearings was going bad. This drove me crazy for a couple of weeks since...
@Jack: I do get down that way periodically, I'll ping you next time I head out.
- Dave
Thank you Dana. What was your source for a prox switch?
Ok all you Z-Experts, here's one for ya:
Great thread -- thank you kindly. I followed the directions and figured I had it made in the shade.
Context:
ShopBot Desktop with Porter Cable Model...