Search:

My work just put a nice vacuum on ebay with a very low reserve.
It's a Oerlikon Lebold Sogevac SV-300B. Nice vaccum that would make a great hold down for someone.


...

What are people using to cut carbon fiber parts?

Today I broke my composite bit after about 500 parts ( picture attached ) . I don't know what it is and it doesn't have any writing on it. I was...

Thanks for the advice.

Can anyone give my any tips and things to watch out when cutting HDPE? Also does HDPE warp after cutting?

Thanks in advance,

Richard

Thanks for sharing ideas. We are going to use pin for locating and bolts to hold the jig to the table. Again thanks for the ideas.

Richard

I need to make several 3D vacuum jigs that I need to remove and than reposition back on the table. Can people share there techniques for doing this repositioning?

Thanks,
Richard