Search:

Scott, thanks for your reply. I wound up setting the cut depth to a larger amount that was going to be used. This worked out well. I accomplished what I needed and didn't break or make funny cuts in...

I'm wanting to ck. toolpath above the part blank prior to plowing unto the material. I've viewed a tutorial about doing this, but I can't remember where. Can/will, someone point me in the correct...

I'm selling my 2007 shopbot Buddy. 24 x 32. Runs good haven't had any problems with the machine. Comes with control box, Porter Cable 7518 router. Collets 1/8" -1/2" extra bits. asking $6500. pick up...

Well, I finally figured it out. Just fyi so if anyone else is as dense as I, The problem was open vectors. I had rechecked for duplicate vectors, and clicked on open vectors and everything lit up....

Thanks Scott. I'm not finding any place to adjust/edit, the length of cutter being used. To further confuse all, I've made 4 cut programs for the chair parts. I produced these programs by using the...

Thanks Bob. I just cked. for duplicate vectors and there are none. This am I tried a change of the thickness of the material to 1" to see if it made any difference. It didn't. I still get the change...

I'm having difficulty with the program (V carve pro) changing the settings. I'm trying to cut parts that are .875 in thickness. I'm using an endmill .312 with a cutting length of 1". I'm also wanting...

I'm trying to cut some parts for a chair which I found in a woodworking mag. I scanned the parts drawing and got a jpeg file. Is there any way to convert the jpeg file into a CRV file? I want to...

Red F I'm interested in your machine. I would like to visit with you if possible.

Thanks Tom. I'm ready to move on. two years is enough. I'm sure there will be someone that wants a low time machine.

This machine is a 5x8 with 12" Z. It's a 2013 with less than 5 hrs. run time. I haven't been successful in doing much with it. So, It's for sale. I've exhausted all the patience I have for it. Asking...

PM sent

thanks Leroy

Is the software included? How close to Indianapolis ?

Thanks Leroy

I'm pretty new here. Haven't posted much. I'm in need of getting some parts made. Would like to find someone close to home. (McPherson, ks. ) or at least reasonable distance.

Thanks

Leroy