The Shelter 2.0 parts would make a great green house, all cnc cut.
http://www.shelter20.com/
Neal
Type: Posts; User: nschlee
The Shelter 2.0 parts would make a great green house, all cnc cut.
http://www.shelter20.com/
Neal
Yes, collets do wear. The Colombo's use ER collets, the size depends on the spindle hp. ER collets can be bought from many metal and wood bit suppliers.
Neal
Here's a Safety Board we recently produced. The text on the main board is V carved .1" deep into Armour Core. Armour core is made using plywood veneer inner cores with .125" thick veneers of MDF on...
Last fridays "News Hour" on PBS had a quick shot showing Obama checking out a Shopbot.
What happened to Physical Design??
We used to buy lots of music movements from National Artcraft.
You might try building coats of System Three's Yacht Primer. It's a thick 2 part water based epoxy, it can be sprayed, rolled or brushed. The stuff sets up rock hard after 3-4 days, probably not...
Mark,
How are you going to hold the pcs. together without the pocket puzzle joint?
Neal
Bill,
I've down loaded the files. Hoping to cut one this weekend.
Thanks again for your and Robert's effort on this.
Neal
Hello all,
We're now selling our RTA EPS & DXF files for CNC.
They're great for Holiday Bazaar sales. Many are items for kids, all are cute, educational and functional. They cut fast, require...
Bill,
What's the width dims of the bows? 4", 6"?
Neal
Bill,
How many sheets of ply are needed for this shelter?
Neal
Not a Contact Cement but PL makes a Foam Adhesive, PL300, might not set fast enuf for your needs tho.
http://www.stickwithpl.com/Products.aspx?ID=300-Foam-Board-Adhesive
In the past when I have had my .25" downspiral 2 flutes bits resharpened the majority come back at .220" with the balance .235". Usually I can run the .235's as .250's but make new files for the...
Nyle supplies blue prints to build the kiln structure with unit purchase. Here in Alaska I could get the container cheaper than the materials to build the structure, makes it easy to move too.
...
Cost to run was 5-7 cents a board foot. It requires a 220v single phase 30 amp circuit. The unit has a pre-heater that only comes on at startup, after the inside temp reaches 80 degrees (4-6 hours)...
$4K 7 years ago, I think they're more like $5K now. Here's some pics. Most insulated containers have stainless walls and aluminum grate floors, and are insulated with 3.5" of urethane foam. There's...
I used to dry wood. We used a Nyle DH Kiln, worked great for birch. Would take a 2K BF load from green to 6-8% in 21 days. Before building a kiln with the Nyle unit I looked into the vacuum kilns...
Bob Condon,
You have mail!
Neal
ER collets are available in many more sizes than hand held router collets, including inch & metric.
8672
Go spindle if you can afford it, hell, go spindle even if you can't afford it!
RB covers it well, another benefit is the industry standard ER collets are far superior to the hand held router...
Why thank you James, and your work's nothing to throw rocks at! :-)
Neal
Aspire design & cut Cribbage Case with pivoting top w/magnetic catch.
7587
7588
Aspire is a great bang for the buck!
Try Rayzist. www.rayzist.com
Forgot to mention, most of the Chinese systems have sealed glass laser tubes. These tubes are water cooled and can be very tempremental and have a short life (1000-2000 hours), if your lucky. Most...