Thanks, Mayo! I slowed everything down today and got better results. I was trying to optimize the cut times so that I could finish two boards in one day but that's not going to happen. I'll do some...
Type: Posts; User: christiangray3
Thanks, Mayo! I slowed everything down today and got better results. I was trying to optimize the cut times so that I could finish two boards in one day but that's not going to happen. I'll do some...
Thanks for your advice, and the link for the bit, Burkhardt. Much appreciated! I just ordered the bits and adapter for my 1/4" collet. I've been snapping the $42 Amanas...they add up!
Thanks for the advice, guitarwes! Much appreciated! The more I've researched this, it does seem that it could be an issue with the bit not being perfectly plumb, and/or issues with the table getting...
I'm looking for a Shopbot Operator with experience in Rhino/RhinoCAM, Aspire/VCarvePro to give paid consultation on a project that I'm working on at the moment. My studio is in Greenpoint, Brooklyn....
Greetings,
I’m running a PRT Alpha 4’x’8’ with upgraded control cards to run current Shopbot software. I’m using Rhino and Aspire for design and assigning tool-paths and G-Code.
I’m cutting 1”...
test
29061
29062