Search:

I guess the problem was in the MTC file. Ryan from Shopbot sent me a new one and it works fine now. Thanks Ryan.

OK, thanks, I will look at that.

27136

Here's a screenshot of the start of the file...

60x120 PRS Alpha, 5hp HSD,single valve air drill, SB Control v3.6.46, SB link 1.0.19

Just had to reinstall everything after my laptop crashed. I've run the SB link the last few years with no...

Thanks Gary, I will.

Hi Gary,
Bit parameter it must have been. I changed the cleanup allowance on pockets to .005" a while back...same thing I recommended to John. I reset it to 0" again and it remedied the...

Anybody had this happen? I'm using a 3/8 bit to cut 35mm pockets for euro hinges. It normally pockets full depth in 3 offset passes, but all of a sudden the passes are not concentric to each...

John,
With the tenon issue set a cleanup allowance amount in the pocket settings, maybe 5 or 10 thou. Worked for me.

Up and running again. While I was messing around with all this, at one point when Shopbot 3 loaded, it only showed the position screen, not the control screen. I uninstalled it, rebooted and...

Brady...I think I will take your advice and run a bare groundwire through the inside of the hose...the hose has a spiral wire in it that's grounded with jumpers, but I'm sure one run inside the hose...

Brady,
I've been on the phone with Gary this morning and he wants me to check the grounding and the Estop switch wiring...in the meantime I've sent him the export files to look at....really...

Ken,
The problem has never arisen before with any other software. Here is the sequence of events:
Shopbot 3.38 opened by Shopbot Link
output 4 on, input 1 off
ENTER SHEET # dialog...enter
LOCATE...

There is also the issue of the spindle shutting itself off.

Hi all,
I'm making the jump from KCDW to Ecabinets with my first full kitchen.
I have all the blind dado case parts cut in 3/4 and 5/8 perfectly with .374 bit (#11) and 5mm air drill (#31). Now...

Thanks Dennis

I left a voicemail with Thermwood on Monday, but they haven't got back to me. They took the computer as well, but dropped the computer by the road and drove off when our neighbour came out and saw...

Hello fellow Shopbotters. My Shopbot link USB hardlock was stolen from my shop last Sunday. Serial #0047. Please let me know if anyone tries to sell you one. Thanks
Dave