Search:

Type: Posts; User: rb99

Search: Search took 0.02 seconds.

  1. Replies
    12
    Views
    874

    With my old controller it had a "motors off"...

    With my old controller it had a "motors off" command and I could manually move the router into it's final position. I had the old ball screw Z. I would put a piece of paper under the bit and turn the...
  2. Replies
    12
    Views
    874

    If forgetting the clamp is an issue, perhaps...

    If forgetting the clamp is an issue, perhaps making it with a break-a-way using magnets would help?
  3. Replies
    12
    Views
    874

    What I want to do is have a plate or something...

    What I want to do is have a plate or something that allows me to quickly zero the X Y and Z axis'.

    I am not sure which plate you are talking about. Since starting this thread I found the one I saw...
  4. Replies
    12
    Views
    874

    Help With 3 Axis Zero Plate

    I am looking for a way to zero the 3 axis on my older shopbot with a 4g controller. I remember there were aluminum plates with a recessed hole that the bit goes into the hole and touches 3 sides and...
Results 1 to 4 of 4