Search:

I have been gone for quite a while and as usual, forgotten a few things. I would like to find past threads I have asked and had answered. I know it can be done but how do I find the old threads? They...

Got what I wanted to work. Thank you for the help and replies.

Sorry but I have forgotten how to automatically repeat a file over and over. I dont want to stop the spindle just need it to move to a safe place, insert my new material, pause a defined time and...

I just found it. You did beat me to it! Thanks

Im getting old. I just installed the new Aspire 10.5 version on my new computer but when I go to Post Processors my correct Shopbot procesors are not listed. They are on my older computer, but being...

My problem happened all within ten minutes. I never changed a thing machine nor program. I’ll try resetting utilities as you suggest to see if that clears up the problem. If not all I can think of is...

For some reason last night my PRS Alpha wouldn't run correctly when I did a C3 command. I've tried all day but to no avail. Maybe getting old has something to do with it. My proximity switches all...

Jerry Ill call them and see what they have. Thanks!

I have a Shopbot ATC and am getting quite tired of putting the ground on the bits and then applying the zero plate to tell the program where the surface is prior to cutting. Most all the newer CNC's...

Gene I do believe you are correct. Thanks.

I just purchased Vectric 9.5 and am confused how to go from Vectric 9.5 and print to my Epilog Laser. I can take a picture into 9.5 and do what I want with it but when I go to print to the laser its...

I have the ATC that is 5X10 and I do like it. I have 10 tools that are capable to be used. I had to change the tool changer file but it has worked out quite well. The down side is the dust shoe. I do...

Steve, thank you for the information. I appreciate it! I'll look it over and if need be I'll ask any needed questions. Thanks for the offer.

In the past I have seen someone that had made a file that would be helpful in making a "Bun Print" into the seat of a wooden chair. Does anyone have that file? As Usual I didn't think I would need...

If I am reading you post correctly you want to cover your cracked or aged dashboard. There are companies that make a product that is an exact duplicate of the original dash. It is very thin and it...

Can someone point me in the direction of the "geared" door that was on the forum about 1-2 years ago? It looks like it would be in a boat bulkhead and opened by way of a wheel and gears located in...

Just sent you a PM. Please read it. I have a ten tool unit and it works fine!!

Send a PM to me. Maybe I can help.

Bob for the job that I think you may be trying to do I would use a flap sander. You can buy heads of make your own by stacking the sanding fingers. They aren't too expensive and actually do a descent...

Tim the grit I use between coats like lacquer or paint is the 180 grit. You have to remember that the machine is variable speed along with the brush being variable speed. In other words you have the...

Lucas sorry the long delay for my response. I own the SuperMax Superbrush 36 inch unit. First you have to make sure you have a very good dust collection system. It will put off a lot of fine dust...

I have one but am not close to you. You can ask questions if you want and I will answer.

I just tried mine and the air is off and no power applied. The spindle spins freely. Just some extra information for you.

I have the ATC myself. Yes, it will spin freely when not powered. I can only guess what may be the problem. I would look to see if the release that releases the bit is some how causing the problem....

Jack be very careful with what you use to remove the stain. If you use acetone or lacquer thinner it may just remove the stain but leave the finish with a hazy finish. It may very well slightly melt...