I'm not sure if this is documented anywhere, at least not that I could find, but I got this figured out so I thought I would update the post in case this happens to someone else. It turns out that...
Type: Posts; User: amorgan
I'm not sure if this is documented anywhere, at least not that I could find, but I got this figured out so I thought I would update the post in case this happens to someone else. It turns out that...
I realize this is an old post but this same thing has happened to me. I had to rebuild the computer and now PartWizard doesn't add in the header to the files. What was the fix for this?
...
Rob thanks for sharing.
Did you have to hand cut the inside corners of the finger joints since you used a 1/4" bit?
Dovetail and finger joint templates are cut with the bit in-line with the...
The x-cad.net domain is registered to Donna Fallin or Donn Fallin in Austin Texas. It could happen, but it seems a little odd that someone would miss spell their own name.
Are any of the major...
Thanks for the help on this. It seems counter intuitive, but cutting faster (to a point) makes a better cut. As you pointed out, the trick is getting the right chip load (a combination of...
Thank you - that was what I needed.
Is there a listing of the current system variables associated with the current (3.3.18) version of the software? I've searched all over and all the information seems to be out of date (e.g. past...
I see in this post that some are recommending fast speeds cut speeds for aluminum and others slower feed rates. For routing, do I just have to do a lot of experiements (and go through a lot of bits)...