Search:

Type: Posts; User: Chuck Keysor

Search: Search took 0.02 seconds.

  1. Replies
    10
    Views
    1,928

    Thank you Kenneth....... I'll have to look at my...

    Thank you Kenneth....... I'll have to look at my frame,,,,, but it never seemed to me that mine wobbles much. Maybe I run things too slow............ Chuck
  2. Replies
    10
    Views
    1,928

    Hello Kenneth. I am still fiddling with some...

    Hello Kenneth. I am still fiddling with some other parts of my Bot, so I haven't yet been able to test out my welded gantry. When you did your gantry welding, how would you rate the improvement? ...
  3. Replies
    10
    Views
    1,928

    Thank you Dave. I appreciate your positive...

    Thank you Dave. I appreciate your positive feedback. Best regards, Chuck
  4. Replies
    10
    Views
    1,928

    Thank you Brady! Speaking of "riser...

    Thank you Brady!

    Speaking of "riser blocks", while I have of course welded the 1.5"x 2.5" rectangular steel tubing to the 3" square steel tubing, I did not weld the long angle iron pieces to...
  5. Replies
    10
    Views
    1,928

    Part 3 Then I put the X carparts back on my...

    Part 3
    Then I put the X carparts back on my Shopbot X rails, and fumbled around to get the longbrackets bolted on to the 3” square tubes, to restore my nowadjustable X motor carriers. (Picture I)....
  6. Replies
    10
    Views
    1,928

    Part 2 And then because thelong angle brackets...

    Part 2
    And then because thelong angle brackets were attached by bolts to the bottoms of the 3”square tubing, I was free to move the X gantry until it was in factsquare to the X rails. (Picture E). ...
  7. Replies
    10
    Views
    1,928

    Welding my X gantry (Part 1 of 3)

    Hello Shopbot Friends. I had to break this into 3 posts, with 4 pictures being the limit for any one post.



    Part 1
    Last September, in a quest to improve the rigidity of my X Gantry, I...
Results 1 to 7 of 7