Search:

David
Which, if any were 220v single phase?
Do you have three phase?

There is a problem called "single phasing" whereby one leg of the circuit goes soft/low/to zero and wreaks havoc on...

Don: You are welcome, I'm with you on a release soon.

Tim: After I found the incorrect fronts, I retraced all my steps...from the ecab model to the SB. As I'm a relatively new user I thought it...

For those of you using eCabs/SBLink I ran into an issue with ShopBot Link 1.0.18 that has been confirmed as a bug by Thermwood. It has to do with how SBLink handles door and drawer fronts grouped in...

Here's an idea derived from sponge-ing this forum...works great if you have a higher ceiling (mine are 12ft). might be tight in a typical 8ft ceiling.

I haven't seen boring bits in "Imperial" shanks.

I'd suggest using Amana boring bits. (see link below).
They have a 10mm shank, which is std on many euro machines. (line boring/hinge machines,...

Excellent Gary. Thank you!
Had a feeling it needed to be coded in...

How does one set the SBLink flip op fence locations?

I scoured the manual and all 'Link dialog boxes...I must be blind, or jus' stoopid.

Note: I do not wish to do "Flip Ops First" as I am using...

I'm going to test a couple more things, before I use up any more of your time Gary. Once I do, if I still am scratching my head, I'll send the export file to you. Thanks for the offer to inspect...

OK OK OK oh great one...that was the glimmer I was referring to...thought so.

Now, say I set my pocketing tool to the wee 5mm and appropriate feed/speed, etc...am I now limited to doing all...

So I've scoured the SB and TW forums for insight and am only getting a glimmer...here's what I have:

2011 PRSa with my own ATC system loaded with tools as follows:
1 = 375 CENTURION HIPERF...

Hi All,
Having some unexpected behavior as I get the eCabs>SBLink>ShopBot workflow going and am looking for a forehead slap...

When I send a nest to the SB via the link my drilling plunge speeds...

Hi Todd,
Just went through this myself for the X axis (not part of the SB).
Kabelschlepp is the brand and they have lots of flavors.
I just grabbed some part numbers from the SB supplied Y-chain...

OK, chips is technically correct.
Although that Extira I used for the plenum board made some stuff strongly resembling sawdust...sticky-ish, too.

Outside of the normal SB User's Guide Maintenance...

Wow..thanks very much Gary...but this is still in process.
Lot's to do yet before this beastie actually generates some revenue!!!
What could go wrong? heh heh heh...

First, thanks to all of you whose ideas posted on these forums I have blatantly stolen and pummeled into my machine. Truly, this place is a wealth of info...amazing.

So, I finally ordered a...