Search:

I laminated in a 1"x1" tube steel bar where the branches touch the HDE sign. The bars are welded into the frames in the outer logs.

The boss requested a new monument sign for the San Jose Family Camp entrance. The need was for a sign to fit into the enviroment and not stick out like a sore thumb.

The sign was constructed...

I did not cut the copper. The roofing material was a donation for a roofing company. They had a large quantity on hand that they did not want. It is copper sheeting glued onto composite tile. ...

This was my latest project. A wishing well for a Japanese Friendship Garden. The well is a fiberglas funnel that coins spin down. I am praying the copper roof will stick around awhile before...

I designed this in Coreldraw x2. Produced the toolpaths in Millwizard. I took about 4 hours to cut on my prt 96. The substrate is HDU 15lb. I applied a two part epoxy clay to give the dragon face...

I have a prs 96 with a HSD spindle. I had the older control box. It is not adapted for the spindle but I thought maybe I could adapt using the output 1 switch as I did on my prs 96 router version....

I have a yaskawa drive for a HSD spindle. I currently do not have it hooked up to the shopbot control box to control the on and off by the "SO 1" in the software. I would also like to be able to...

I believe this Sleigh has been used quite a bit by others. We needed a float to put Santa in so I scaled it up to fit on a 8' x 25' trailer. It is made out of 3/8" plywood with EPS sandwiched...

We do have a website. It is www.christmasinthepark.com Thanks for asking.

This was a sign that was requested for the Conference Room at the local Childrens park and zoo. The park was refurbished in 2010 and reopened with all new rides and attractions.

I wanted to go...

This was the story that I started with and the clock took off from there.
Santa's Historical Clock:
Beginning in 1836, this historical clock was installed in the clock tower located in...

Thank you for the compliments.

This project took about 3 months to make. I worked on it on and off with some volunteers.

The gears were designed in Rhino 3D. I then exported the dxf files...

It has an exterior 3/8" ply with lightweight metal studs in the walls. The interior walls are OSB. They make a great wallpaper texture when painted. Boy does it stink when you paint OSB with latex...

It started with one gear. I have a prt 96 with a porter cable router. I wanted to try just a gear and see what I could do. Someone had giving me a stack of 5/8" pressboard. Then another gear. ...

I have a zero plate input giving me problems. I have connected the wire properly and when I touch the zero plate to the bit the input light one comes on like it should. When I run the zero plate...