Search:

I called the mother ship and they sent me a PDF file describing changing all of the power saving modes as you discussed earlier. I did that and was then able to download the latest Sb3 version. I...

Brady,
I'm on the way to the shop now to check all of the settings that you mentioned. You might be on to something because my monitor does go black after a while so the power savings mode could be...

How many times did you run it Jerry? It usually runs fine the first time and then on 2nd or 3rd run it glitches.

I see my 100th post went from MEMBER to SENIOR MEMBER. Perhaps this is just another one of my reoccurring "Senior Moments"? :o

I don't touch the computer while the machine is running. If something is switching on and off internally then I have no knowledge of it.
My dust extraction hose is not connected either. I removed it...

I am going to admit my ignorance and say I don't know what a post processor is or how to try a different one. I don't have my PC connected to the internet and nothing else is running in the back...

I am not running this file from a TD. It resides on my C hard drive and that is where I run it from.

I used PartWorks 3D to draw this file and have an intermittent glitch. I don't know if the problem is in the PartWorks 3D file or in my ShopBot Buddy machine?

It is relatively simple file to put...

I tried to install the latest V-Carve Pro patch to my Shop Bot's PC and it crashed it. I get an error message that MSVCP100.dll file is not found. I searched for that file on my office PC but can't...

I currently have a PC and my ShopBot Buddy runs on a PC however I am considering purchasing a MAC. IF I do purchase a MAC then I will have to transfer all my PC shop bot / Part Works files to the...

French Polish is not a material but a hand applied method of applying a finish product. Fresh mixed flake shellac, often mixed with other exotic resins, is the most widely used materials. FP is a...

Oops, Thanks Don, too!

Thanks Scott. That is EXACTLY what I was looking for!

I am doing this out of need for the design . I only have 2D software and realize the type of cut I want to make is actually a 3D design feature. I was just hoping to be able to do this with...

Does the ramp work on both ends of the cut?

I am using PartWorks and tried the Lead In function with a 20* angle and it did not work??? What angle should I use? The default is 90*

I want to gradually enter a cut and exit it the same way. I want the bit to gradually taper into the wood from the surface for a length of 6" then make the cut at the desired depth and then exit in...

I have version 2.5 but when I try to run the upgrade it says it can't find PartWorks on my PC? What now?

email sent. Thanks

Can anyone teach me to model a 3D concave bowl shape? I need to make a few, all with different radii and they are all 24" in diameter. I don't have any 3D software except Cut-3D. Can that software...

Lets say you are going to V-carve a sign in Oak and you want the letters painted black and the wood finished natural, how to approach this project? Do you V-carve bare wood, hand paint the letters...

How do you resharpen carbide bits? I assume diamond stones but by hand or power?

The "kit" Onsrud V-bit is worn out and now its time to replace it and broaden my selection of V-carve bits. Looking for "cost friendly" bits that last long, stay sharp and won't have to break into...

Looking for a durable V-bit to V-carve into Formica "type" faced sign boards. I am using Pergo type flooring for carving small signs. It really works well BUT the downside is I am only able to cut a...

I am looking for a script font that joins all of the letters together like you would when writing cursive. I need to cut some letters out that are cursive and are all attached to each other. Any...