I reinstalled the SB controller software, reloaded control box firmware and set z offset (c8) at 1" and it is still doing it, is there a way to manually change this setting? Thanks.
Type: Posts; User: Art Sign Works
I reinstalled the SB controller software, reloaded control box firmware and set z offset (c8) at 1" and it is still doing it, is there a way to manually change this setting? Thanks.
Our 4x4 Alpha keeps moving all the way up to the Z-Prox switch after we manually zero a bit. Can't figure out how to turn this off. All of our other Shopbots with manual tool change stay at 1" above...
I have a PRS Alpha 120x60 w/ ATC built in 2009, recently one of the X-Axis motors started vibrating pretty vigorously during small movements, I noticed it first during the C3 Homing routine. I ran a...
For the last week, with growing frequency, my ATC Alpha will quit during runs and give a driver motor fault on the Z-axis. I have rewired the motor, re wired the prox switch on the Z-axis and even...
Thanks Brady---the X and Y were switched, I changed it back and we are good to go! I appreciate your help. What would have caused that to change (just for future reference)
I fixed the Motor faults, but the X & Y axis are still switched in the control software...we haven't rewired anything, it just happened one morning. I reloaded the control software and still is...
We are getting a Driver/Motor fault when running the C3 homing routine, we made sure all the rails were clear and nothing is physically blocking motors, still getting it. Next, the X-axis control in...
Thanks, I will try both suggestions. I appreciate your advice.
Recently started happening, we run a 1/16" end mill first, then change to a 1/2" end mill to clear and the 1/2" bit runs about .010" higher than the 1/16" bit did leaving a step up in the material....
Thanks Randall, we work with James and vector art 3D all the time, his turnaround is 6-8 weeks now. We need the file within the next couple weeks.
Hi Steve-
Yeah, it needs to be in 3D raised, not V-Carved. This is what we are looking for. Thanks.
http://epicroadtrips.us/2007/summer/california/D4/web/hres/ert07CA_D4_06.JPG
Hello All-
We are looking for a .v3m or .stl file of the seal of California. We will pay, would negotiate price. If, not I would like to pay someone to recreate it for us in .v3m or .stl format....