also took the good sounding x drive motor put it on the bad side and it gets the noise
Type: Posts; User: paul60
also took the good sounding x drive motor put it on the bad side and it gets the noise
resistor is hooked up
hi jerry still having no luck trying to solve this problem
yes i know the x stepper that is giving the problem
i took the motor of and connect on the opposite side. the motor ran smooth
the...
Yes jerry will try that today. Thanks
Can a faulty gecko drive cause a stepper motor to run erratic?
One of my x motors is noisy and lock up sometime in the middle of running a file
Thanks
Hi Kenneth
Got it working
Now another problem has come up one of the stepper start making making allot of noise. I took of that motor and connected it to the smooth working motor supply and it...
Or should I just take the red and blue and exchange there position so it become from left blue red
Hi Kenneth thanks for your help just to make sure i have this correct
from the left of the plug the colours goes red blue then green black
so one pair will be red blue and next pair green black...
I need to reverse one of my x motors on a prt96 Shopbot
Vexta a6497_9412 ktg. Need to change the
Physical wiring to reverse on the motor connector
The wires on the connector is black green...
Running mach3 on prt 96
my motors are slaved running off one Gecko drive.
motors started running in opposite direction.
how do i reverse the direction of one motor?
thanks for your help. Paul
Hi i am running a prt 96 with cvarve pro and Mach3
been cutting a number of letters this morning after a few min cutting i heard a thump after the job was completed i then notice allot of the...
Hi can anyone recommend where i can purchase a computer with a parallel port. Ebay amazon or anyone that ship outside the USA
computer brand and model type so i can search from my side.
thanks .
Thanks Joe will try make cnc
Does anyone know where i can obtain files for dollhouses?
I purchase a couple from Esty both were rubbish never got them to work.
I do not have a problem paying for a good file if it works.
Thanks
running Mach3
few days ago moving x axis using key board arrow keys.
x will only move in one direction makes no difference what x axis arrow i use.
shutting down andstarting up correct the...
what the font worked thanks
Does anyone know this font? Thanks Paul
Hi Burkhardt
I received a .125 sheet of this styrene stuff from a sign company, to cut out door hangers for a hotel.
This is the first time i have seen this stuff.
but its not brittle. I can bend...
Just wonder what type of bit is best used for cutting Styrene .125 material?
Thanks Paul
I have been working for a sign company . And ending up with hundreds of ends.25 and .375 pieces . Ranging in sizes from 2ft square down
Have been cutting them up and just dumping them
Someone out...
94.90x39.76
thanks everyone I got the customer to send files as a dxf
makes life easy
I have been sent a pdf file from a customer.
when i view the measurement of the pdf file by putting my mouse on the left bottom corner is says 96x41.35
but when i open pdf file in vcarvepro is...
I don't cut that many very small parts. Smallest I cut is about 1.5x 1.5. Most of my cutting a much larger.
All the cutting I have been doing is in pvc.
The only 1/8 bits I have is up spiral and...
Hi Knight
where did you purchase the 1/16 bits from?