Do you use it like that all the time or do you use it with the dust foot???
Type: Posts; User: oscarg1971
Do you use it like that all the time or do you use it with the dust foot???
Does anyone know if Shopbot still makes that black cover that went over the Porter Cable router exhaust openings that redirected it up instead of straight down onto the table??? TIA
How much does it weigh??? Thanks
I agree with the dowels. One of the easiest ways to register both sides of your project.
So that would be the 26th and 27th, correct???
Beckwith Decor is who I go with for my 3D cutters also. -Oscar
Here's a new project for all to cut. Hope ya like it. :-)
http://www.shopbotbuddy.com/projects_quiltrack.html
Sorry to hear that Eric. Hoped it would of worked out for you. -Oscar
Phil, this is for PartWorks 3D, so there isn't that option anyways. It would be in Parkworks though. -Oscar
PW 3D wont let you save 2 different bits in a single toolpath. It has to be the same bit. Right below the toolpath selection there's a note, "The toolpaths use different tools and the selected...
Is called Parallam. It's engineered wood normally used for roof spans. It was sealed with 4 coats of a Spar Urithane.
http://ilevel.com/roofs/r_ParallamPSL_beams.aspx
Here is a project that I worked on with Grant Bailey. With his design and my tools it turned out quite nice. :-) -Oscar
http://www.flickr.com/photos/angelicdiablo/
Don't forget the guys @ VectorArt 3D do design if it is something in particular you are looking for. -Oscar
I think the nesting module will be in VCP5 and also in Aspire with the next software update. -Oscar
Art, you might see if you do any 3D reliefs. Thats really when it happenes to me. -Oscar
Jim, I move my BT48 around quite often. I have the casters and only lower and raise one of the feet. And that's only to keep it from moving once I have it in place. It keeps it very stable and it...
Gary, it does work. Just copy and paste it into your browser. -Oscar
Jim, it's dead center at 22 1/5" on each side. No need to offset it. -Oscar
Hi Bruce, the finishing pass took just over 12 hours @ 3 IPS with an .125 BN and 10% stepover. If you look at the setup manual for the powerstick, it does give some info on using the PStick on page...
Mantel is done and the PowerStick performed flawlessly. Great job Shopbot!! -Oscar
http://www.flickr.com/photos/angelicdiablo/sets/72157604075473143/
It sure does!! -Oscar
I'll let you know in the next day or two. I was asked to cut the VA3D Grape Mantel. It's about 5' long and 8"wide. It's cutting on a piece of cherry that's 6' X 10" X 1.5". I am roughing it now...
There nothing wrong with the PowerStick at all. It works great. My issues were with a few missing parts. Once Shopbot was informed, they shipped them out to me right away and I was able to...
Finally got my table installed after a few snags. It works great and I'm ready to cut! -Oscar
http://www.flickr.com/photos/angelicdiablo/sets/72157604075473143/
Got my PowerStick outfeed supports installed this morning. Should have the table on tomorrow and cutting by the end of the day. More pictures to come.
...