The reason i noticed the 1 input wasnt working is because i did the C2 routine and it didnt stop and broke the bit. Lets be real. Not doing that again anytime soon.
Type: Posts; User: cradke0419
The reason i noticed the 1 input wasnt working is because i did the C2 routine and it didnt stop and broke the bit. Lets be real. Not doing that again anytime soon.
I went to zzero my bit and noticed the 1 input wasnt working. So i cut the end of the wire figuring it may have just bent and broke there. Hooked it back up and still nothing. Any idea on where to...
sorry it took me so long i figure you probably already have it figured out but may help others
http://www.thermwood.com/download/Temp_Storage/Clint/ShopBotLinkSetup1_22_3.exe
I am trying to make a hold down for planing slabs. I bought some unistrut to act as a t track. Planning on bolting that down on the bed and using wedges to keep the slab tight. Also thought of...
I contacted thermwood and they emailed me the link
thanks for the quick reply I have been looking and reading forums but everyone I click on and look at leads to a dead end with a 404 error page
Where do I download the shopbot link? I purchased the dongle a few years back and bought a new computer but cant seem to find where to download it from. Sorry for the elementary question
I will have to try that torch trick. Thanks
Thanks guys. Yeah I am going to have to break those edges. They have a few sharp spots. Is it OK to run the vacuum hold down for extended periods of time?
33761
I don't know why I didn't think of this earlier but this tool is awesome for cutting tabs. Too bad I figured that out on the last sheet!
33760
Need to make 18 of these things by Monday. Donating my time for this project but hope it helps. Don't know what to think about the one time use and probably never used again but I guess...
33759
I haven't cut plexiglass before but those edges are as smooth as can be. Very happy with the results. They are just a barrier between the poll workers and the voters sitting on a table. ...
First one done. What do you guys think
ATTACH=CONFIG]33757[/ATTACH]
Was thinking about making it more eye pleasing than 2x material. Thought about something like this. 33755
3375433754
Need to make some plexiglass dividers for voting booths. I have 4x8 sheets 1/8" thick. Was going to cut them in 3rds and make them 48x32 approximately. Need to build a base so they can stand up on...
I just cut out about 20 sheets of plywood for cabinet parts using ecabinets and the spindle shutoff each time like it should. Used vcarve and it would not shutdown
I have issues with the spindles shutting off after it is done cutting a file. I have 2 Colombo spindles with delta vfds. I pushed the mode button on the spindle and it goes to a different number...
Hello I am looking to try making a topographic map of my area. I am not very good with vcarve pro yet but I'd like to try. Any suggestions on how to get started and what material to use. I am...
Thanks for all the replies and help so far. I do appreciate it
I have since changed my dadoes to be .035 to make them fit good. Looking at the fit I know something isn't right because there is not 1/32" of slop in the joint. I set my plywood to .48 and my...
Right now I'm setup to zero off top of material. I am wondering how to change that to go off the bed so I don't have to rezero when I change material thickness. Does it have something to do with...
Thanks that helps to see what other people do. I use a 3/8" bit for outline and dadoes in the z axis and have a 5mm in the a axis.
I changed some settings and now it's much better. It was set to .01 and I changed them to .025 and it's good. Thanks again for your help