Search:

Type: Posts; User: Brett Whitman

Search: Search took 0.01 seconds; generated 8 minute(s) ago.

  1. I would like to buy.

    I would like to buy.
  2. Will you ship it to Colorado or do I need to pick...

    Will you ship it to Colorado or do I need to pick it up?

    Brett
  3. Replies
    8
    Views
    6,718

    We make Mah Jongg tiles. Anyway, thanks for...

    We make Mah Jongg tiles.

    Anyway, thanks for all the input. It sounds like we've reached the limit on minimum engraving line width.

    Brett
  4. Replies
    8
    Views
    6,718

    Smallest V-bit?

    I am using a 1/8" dia. 30 degree V-bit with a (claimed) .004" wide point.

    I cannot achieve sufficient detail using this geometry.

    Do you know of any pointier v-bits available off the shelf? 15...
  5. My New Router?

    I think I can use this, PM sent.
  6. Replies
    6
    Views
    5,771

    How Awesome is ShopBot?

    This is my shop on November 8, 2018; consumed by the Camp Fire:

    32303

    This is my shop on December 6, 2018; open for business:

    32304

    Our recovery would not have been possible without the...
  7. Desktop Porter Cable Router Won't Turn On

    The relay clicks on, the router starts to spin, the relay clicks off. Total time between its trying to start and giving up is less than one second.

    If I turn off the key, the relay does nothing. ...
  8. Replies
    3
    Views
    10,926

    Yes, thank you, either should work. ...

    Yes, thank you, either should work. Unfortunately I don't yet have the needed language skills. Also, plan A didn't work out either so for now I'll just have to do a bunch of typing.
  9. Replies
    3
    Views
    10,926

    Step & Repeat

    I have a Desktop and would like to create a step & repeat program. I think I can reset my zeros and replay my program (RA, RI, M2, Z2, RR) but will have to come all the way back to the original 0,0,...
  10. Replies
    10
    Views
    5,860

    So far, so good. Can't thank everybody enough. ...

    So far, so good. Can't thank everybody enough. Will incorporate more of the excellent suggestions on the next spoil board.

    29288
  11. Replies
    10
    Views
    5,860

    Scott, thanks for the quick reply as I need a...

    Scott, thanks for the quick reply as I need a solution today. Actually, I needed a solution yesterday but did not know that until I made scrap today. I was able to learn that BBPly and HDO are...
  12. Replies
    10
    Views
    5,860

    EZ-Loc / MDF Failure (again)

    I have no idea what I'm doing so please laugh in private.

    My spoil board on my Desktop is MDF and I use two locating pins and two 8-32 machine screws to secure my work piece. The screws go into...
Results 1 to 12 of 12