rocking chair cut file

[ttwark]

Good morning, Shopbot has used a small rocking chair cut file to demonstrate its cutting before. I have looked but can't find this posted anywhere and wondered if someone could direct me to the proper area where I might find this cut file if it is available. Thanks, Deb (Tom's wife)

[gc3]

There are a couple crv files posted on the v carve pro forum

www.vectric.com

[don]

Here is the thread on vectric site that has a couple of a knockdown chair and a rocker.
Forth and Fifth post on the page in the link.
Hope this helps

[ttwark]

Thanks, guys! Deb (Tom's wife, who loves to use his Shopbot!)