Nat...
You just liked it because it worked in Metric!
Glen...
Here is a short video using the new files. Hopefully this will make a manual tool change routine for all.
http://www.youtube.com/user/Islaww1#p/u/0/T1mfLqIfxu4
Nat...
You just liked it because it worked in Metric!
Glen...
Here is a short video using the new files. Hopefully this will make a manual tool change routine for all.
http://www.youtube.com/user/Islaww1#p/u/0/T1mfLqIfxu4
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
Hey nice Gary. Man makes me drool everytime I watch the alpha jog at that speed. I think the screen read 25 ips. The max I can jog my standard is 5 ips. Looking good. Nice big monitor too.
What type of felt are you using? Or what is the part# for Mc master Carr
Thanks
alan...
I dont have the part number, but it is white wicking type felt.
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
this is the stuff I used fron Mc master carr #5051k94 if it help
On McMaster I see two different wicking type felts; what is best to use extra firm or soft?
John...
Caught me at the computer. Looked up my old order. McM part#
8344K97
Hope that helps.
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
Thanks Gary. I was thinking the "Extra Firm" might be a little tough to get to conform around the v-wheels.. Anything special about the oil you are using to soak these in?
John...
I soak them in compressor oil. For ease, I add WD-40 with a hand pump bottle or the compressor oil every couple of days. I use the WD when I take them out for cleaning.
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein