Mike, let me be the first to encourage you to post the files.
Randy
Mike, let me be the first to encourage you to post the files.
Randy
Randy
These are the .dxf files for the v-carving front and rear of Santa
15910.gif
These are the outline files. I made them in two pieces of 50mm(2") foam and stuck them together.
V-carving isn't deep (10mm)so you could cut them back and front of a single piece, if you want to play with registration!
Shopbot file is nearly 18,000 lines, so I guess any files will have to be emailed.
I will put the set together as .dxf and .sbp, with ,jpg's of each
Anyone want them email me. I will give it a week then email them all out together.
There is, of course, no charge
.............Mike
Mike:
A great way for you to share these would be through project wizard. I bet if yoou sent them to Bill Young he would add them to the files available to all.
Dave
Did anybody get the files I emailed?
Robert,
If you sent them to me, I did not get them.
Here they are in 'quick & dirty' EPS format. Should pull right into PW, Insignia, Pro & VCW. I did a quick trace on them, so you'll want to edit & tighten up some of the spots to suit your needs...Can't take away all the fun!
-B
StNick1.zip (20.6 k)
StNick2.zip (13.6 k)
StNick3.zip (4.2 k)
StNick4.zip (4.2 k)
Robert, I did get the email... Thank you.
Brady, It is OK with me if you "take away all the fun" right now. I am in "rush" mode till Christmas. Then I'll be looking for some fun till the spring season starts up again. :-0
Ed,
You're gonna make Santa cry if you are not an expert at node editing by the end of this year.
-B
Well I cannot make Santa cry Brady. I'll have to get right on the node thing. That is the North Node right?
Yep...just make a left at 5 points, go around the bezier curve just beyond the straight span bridge.
I just imported the 1st file and fixed the crossed nodes (didn't see them before export)...ALL of you guys should know how to do this! I have done the 1st one, and believe it or not...I am also hit with the Christmas rush here too already...So you guys will have to tackle the other ones.
-B
Nick1_Fixed.zip (20.6 k)