Best buy on 3/8 compression cutters ??

[tgm]

I know everyone has their own opinion but is there any consensus as to the best cutter for the money, for cutting 3/4" melamine sheet goods?? We currently use a mortise compression as we are cutting 1/4" deep pockets in the cabinet parts also.
Prices seem to vary all over the place and we have always used a well known brand that is getting quite expensive thes days. We are just looking for a good cost effective alternative.

Thanks guys,

Tom in PA

[evan]

Check out this thread: http://www.talkshopbot.com/forum/showthread.php?t=1915
I'm now using these bits but have no other affilliation with the company.

[cabnet636]

i gotta admit i am still using all the bits jerome has sold me! i wish he would make taper ballnose 1/8th and 1/16th as well as 1/4 up/down spirals and "O" flutes for plastic and aluminum

jim

[daski]

We have been using Centurion. We cut 3/4 using a 1/4 compression in two passes. The bits stand up very well. The customer support is GREAT. Call Fred and order a couple. You will be satisfied, I'm sure!