Senior Member
Outside Corners
Does the slow corner speed control the speed at outside corners? I'm cutting some parts at 6ips, 12.5K RPMs, with the SCS set at 90%, and the outside corners are cutting painfully slowly (bit screaming at corners). Rectangular parts/square corners. I should know this by now, not clear what the issue is. Thanks.
Senior Member
My machine always screams a little at corners because of the feed rate slow down. It hums along nicely on the straight-aways though.
Don
Diamond Lake Custom Woodworks, LLC
www.dlwoodworks.com
***********************************
Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!
If you make something idiot proof, all they do is create a better idiot.
Posting Permissions
Reply With Quote
