I've been playing with this file for a while, I got the original pieces from a 3D model
http://www.shuttlespace.com/rochorse.jpg
rocking horse.sbp
rockhorse.zip (9 k)
I've been playing with this file for a while, I got the original pieces from a 3D model
http://www.shuttlespace.com/rochorse.jpg
rocking horse.sbp
rockhorse.zip (9 k)
The file starts at far right and goes into negative numbers on the X axis.
Its for 3/4" material, the legs can be doubled up or single, the notches should end up being 3/4"
The holes for dowels are 3/4 for the handles, and 1 1/4 for the cross pieces. 1/4" bit