I find on my cu butt files from Aspire the command SC followed by 1,1 or 1,0 but I can not find it listed in the command listings.
I find on my cu butt files from Aspire the command SC followed by 1,1 or 1,0 but I can not find it listed in the command listings.
SC is clear user variables. Are you sure you're not seeing SO,1,1 which is set output 1 to on and SO,1,0 which is set output 1 off. This is normally used to start router or spindle.
Ken Zey
Lookout Mercantile / Digital Millwork
Rogers, AR
www.CedarSlabSigns.com
www.lookoutmercantile.com
www.digitalmillwork.com
6x12 PRS alpha
Ken is partially correct. [S] [L] is clear user variables. You probably have the [S] [O] which does turn a spindle or router on (or off depending on 0 or 1).
[S] [C] may be a legacy command that set to single step mode. Hasnt been used in a long time
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
If you're looking at the file in the ShopBot editor you might find that what you think is SC is in fact SO.
The font used in the editor makes a capital O look like a capital C.
AS Gary says the SO command is used to switch the outputs. SO,1,1 usually turns the spindle on and SO,1,0 turns it off.
Thanks all-when I look closer is see the very light part of the O. Thanks all