I have too many questions to do a search. I am cutting the 10 commandments into a marble looking piece of corian. The lettering will be less then .5 inches and the commandments will have an ornamental scroll around them.

Here come the questions:
What v bit for lettering?
I am thinking 60 degree for the scroll?
Can i do a profile cutout in corian with a scroll?
Can you use tabs with corian?
If so can you cut them with a jig saw?
I have a pc router so what feed rate?
What speed of the router itself?
What depth of cut?
Can you paint the graphics in corian?
If you can paint, enamel vs latex?
Does Corian allow paint to bleed?
Can you sand any excess paint off with 220 sand paper?
Can you laminate corian with polyurethane or just polish it?

I know 20 questions but i sure could use yalls advise.