Bought a couple of brad point bits in 1/8" and 5mm sizes from vortex. Wanted to see how they would do for pilot hole drilling and system hole drilling using my spindle.

1/8" is set up as tool #14, .125" D, 3k spindle speed, max. penetration .5". Drill type an is operation #1.

5mm bit is set up as tool #15, 5mm D., 3k spindle speed, .375" max penetration, Type: drill, Operation #2.

.25" M.C. bit for all the rest of the cutting.

Output the file to SB and run the first sheet. (no more bit slamming into material : ). SB3 calls up tool #3 correctly and proceeds to drill out all the holes on the sheet, INCLUDING 5mm system holes!

I've been looking around in the link settings to see where something might be out of place but everything looks in order. Anyone have an idea on what to check for this problem?

Thanks,
Tim