Aspire Camp @ McGrews !!

[cabnet636]

Aspire Camp @ McGrews !!

we have worked out the dates for the camp and James Booth, and Tim Merrill will be speaking, ther will be others, the dates for the camp in columbia sc is march 9-10 2012

if you would like please post here for a willingness of pre registration and i will post a pdf with info to mail in later today!!

[tlempicke]

Put me down. E mail is tom@lempicke.com

[harryball]

I plan to attend.

/RB

[cabnet636]

met you at the vectric booth (IWF) in 08 looking forward to seeing all again !! ryan patterson will be one of the speakers on toolpath templating and gadgets !!

[harryball]

So far these speakers are jamb up, if you don't learn something you must be asleep.

And heck, I could speak too! However, only soft fruit and veggies may be thrown and no more than 4 at the time. I'm not to be held responsible if anyone gets hurt when they hit the floor after falling asleep.

Available topics include:
Vac Clamping Yourself to Your Bot for Profit and Fun
Aspire - If I Can Do It You Can
Cure Aspire Addiction, But Why?
Why Do It in 4 Steps and 10 Minutes When 93 Steps and 3 Hours is More Fun!

But seriously, I'm looking forward to it.

/RB

[steelcnccutter]

I will make some plans to attend also just to see what it is all about...I have never been to a camp yet. steveo

[cabnet636]

i call it a camp, i have called it a gathering, yet for those who have been here before it is a training session and an oppoprtunity to meet face to face outside of a trade show with the fellows from vectric and multiple users of aspire as well as different cnc machines, the shopbot community has always been well represented! two days of presentation and discussion on matters of cnc and vectric software! along with a good southern BBQ lunch on saturday,

[cabnet636]

Finally got the registration done

[cabnet636]

WOW, hanks to all who registered yesterday,, kinda funny how active the fax was, when you think about it it is almost antiquated technology!!

James Booth has asked for subjects of interest so post em!! Ryan Patterson has done some incredible gadgets for aspire and i think we have just seen the begginning of this!

i will email confirmations each week

i belive Kieth outten will give us an update presentation on one of the mornings!! i got to visit one of the cnc printer operations, there is a lot of new technology still growing, i will also show some panel textures that have turned into income

[cabnet636]

we are adding thursday to the scedule for discussion and presentation on the business of cnc and materials