PRS X Axis extrusion

[anthonyjules]

So I know this has been asked before, but I can't seem to find the right answer for my Shopbot.

I am looking for the extrusion that is used for the X axis on a PRS. I have a standard that I upgraded to an Alpha.

From what I have seen it is supposed to be the Bosch Rexroth 40x160mm.

BUT .... the extrusions on my bot measure exactly 6" x 1.5" (or 38mm x 152mm). I have looked around and can't find Bosch or 8020 with those dimensions....

If anyone can tell me what product this is, I would be most grateful.

Anthony Jules

[Brady Watson]

ShopBot may tell you if you call them. The table sides are not Bosch.

-B

[Gary Campbell]

Anthony...
Many(some) of the extrusions used on a ShopBot are custom made for them. They could be similar in appearance to branded ones, but made to SB sizes and thickness'

[br928]

T-Slots, Faztek and 80/20 all have a "15" series which is based on 1 1/2" dimensions. But the largest I see is 1-1/2 x 4-1/2. You can always go larger. They have a 3 x 6.

[gc3]

http://www.techno-isel.com/lmc/produ...tesRE65250.htm

[Rob Gunn]

Anthony, I can tell you its not Bosch. I think it may be Parker?

[br928]

Very good Rob. Parker has a PN 10-1560 that is 1.5" x 6".