This is my first youtube post. It is simply turning a square blank round. There is about a 30 second dead spot before it actually starts.
http://www.youtube.com/watch?v=8MZUddcv3Uc
This is my first youtube post. It is simply turning a square blank round. There is about a 30 second dead spot before it actually starts.
http://www.youtube.com/watch?v=8MZUddcv3Uc
Todd,
If you use the Indexer virtual tool under the TI command, you will be able to quickly turn blanks to size going around the material in a spiral method, which will result in much faster dimensioning than a raster toolpath. Nice to see an SB indexer on YouTube though.
-B
Brady,
Thanks,I am aware of that. I have another video I have not posted using the spiral method. Just wanted to test the youtube water.