Hope I explain myself clearly. This question would only pertain to ATC cutting files. Is there an easy way of editing a file when in the Shopbot 3 program? Lets say I have a file that I want to edit the movement speed of a bit that is to be used within the file. The bit is somewhere in the commands but there are thousands of commands that are to be used. I have to scroll down the list and try to find the introduction of that particular bit and change the movement speed. I find it is quite easy to pass up where I want to edit therefore I scroll numerous times before I find what I want, if at all. My question is how can I find the bit within the file without scrolling down and wasting time? I have tried the search without any luck. Hope I am clear as to what I am trying to explain.