although these turned out fairly good i still have an issue. in the ribbon above police is where it is most noticeable. there is a wavering in the ribbon. the eagle was bought from vector 3d and the badge was built in aspire
i have tried the following:
went from 60 to 90 degree vbit, result more visible in preview
lied to tool data base saying bit was bigger and smaller, no result
i finally decided to just try and sand out the wavering.
in watching the shopbot cut the ribbon, it cut perfectly, it was when the cutting was done around the letters that the bit crossed over the ribbon vector.
i have considered but not tried node editing on the ribbon to try and counter the wavering.
any suggestions are certainly appreciated.