Hi All,
I am curious if anyone knows how to view the RPM dialog box. Normally it pops up when I start the ShopBot 3 software but it doesn't anymore. I've looked through the drop down menus but can't figure out how to get it back.
thanks,
Cody
Hi All,
I am curious if anyone knows how to view the RPM dialog box. Normally it pops up when I start the ShopBot 3 software but it doesn't anymore. I've looked through the drop down menus but can't figure out how to get it back.
thanks,
Cody
PRS Alpha - 5hp HSD ATC Spindle
-best part of life is living it-
The "TR" command brings it back.
D
"The best thing about building something new is either you succeed or learn something. Its a win-win situation."
--Greg Westbrook
thank you this is what I was looking for!
PRS Alpha - 5hp HSD ATC Spindle
-best part of life is living it-
Once it's up, if you click on "RPM", a fill-in sheet will pop up and in that, put a "1" in "Start when SB3 starts".
Scott
Does use of the RPM Dialog Box require a special cable between the spindle control box (in my case the Delta box) and the ShopBot control box?
Yes, it requires one of these from ShopBot (scroll down to 'Spindle Control Boards). Goes from the computer to the VFD
http://www.shopbottools.com/mProducts/spindles.htm
Scott
Hi Scott,
that was a helpful bit of information thank you. I have always had to display my spindle speed by going to tools----spindle control for it to show up, but with that wee gem you passed on it now opens automatically. Thanks.
Cheers and regards,
Roger.