I don’t do much 3d and I get paid for even less. I got hired to make this colonel eagle logo in 3d for a local want wood store. it will go on a desk for a retiring colonel. The logo I got was was too poor quality. but a little more googling (thats what they used) I found a much better quality one. but it does not really have much detail for 3d. so I traced it raised the black and lowered the rest and ended up with the result it is about 9x17 I cut it with a 1/* ball nose at 6ips and it took about 1.5 hours or so.
Then for the same wood place I had them send me their logo so I could make a sample for their store. I imported the picture in 3d then used trace and raised the letters. Since it is still screwed to the table I am debating on running the bit around everything to clean it up.
The vcarved one I wanted the tree different maybe raised but I did not want to change it that much and I debated on the texture but decided to leave it. I carved the large parts with a 120 v the small with a 90 and the texture with a 60