I just put a 3hp colombo spindle on my shopbt. it is driven by a Commander SE VFD.
I have the VFD parameter List, and i have the info Tag on the spindle.
One of my questions is about what others have set their parameters to.
(1) Minimum speed in Hz, mines set a 75 Hz
(2) Max speed in Hz, mines set at 400 Hz
(3) What is the power factor? I don't see that on the tag. mines set at .91
(4)My VFD has a parameter for rated speed(rpm), however the parameter does not hold a big enough value. The manual for the VFD says if this case occurs, use 0 for the parameter.
How does one dertermine the rpm of the spindle?
Can the VFD run the spindle to fast and damage it?