Results 1 to 10 of 18

Thread: Cherry plywood machining advice needed

Hybrid View

  1. 01-26-2012, 01:55 PM #1
    archis's Avatar
    archis
    archis is offline Senior Member
    Join Date
    Feb 2010
    Location
    Towson MD
    Posts
    107

    Default

    Thanks everyone, I get it now. I'll get a compression bit and start experimenting.
    Reply With Quote Reply With Quote
  2. 01-26-2012, 01:59 PM #2
    steve_g's Avatar
    steve_g
    steve_g is offline Senior Member
    Join Date
    Sep 2006
    Location
    Garland Tx
    Posts
    2,334

    Default

    Is the climbing cut an option I set in Partworks when I generate the toolpath?


    Yes, The image shows the option in PartWorks.

    Steve
    Attached Images Attached Images
    Last edited by steve_g; 01-26-2012 at 02:00 PM. Reason: spelling
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Machining plywood that has pockets filled with epoxy resin?
    By MJ in forum Techniques for Cutting, Drilling, Machining
    Replies: 7
    Last Post: 12-03-2014, 12:57 PM
  2. X Y Zero advice needed
    By hhk in forum ShopBotter Message Board
    Replies: 14
    Last Post: 10-26-2011, 07:42 AM
  3. Need Advice - 90 Degree Chamfer on Baltic Birch Plywood
    By widgetworks_unlimited in forum Techniques for Cutting, Drilling, Machining
    Replies: 7
    Last Post: 08-08-2010, 07:15 PM
  4. Advice needed before i cut....
    By myxpykalix in forum Archives2007
    Replies: 6
    Last Post: 10-20-2007, 04:48 AM
  5. Machining strategy advice needed
    By myxpykalix in forum Archives2007
    Replies: 7
    Last Post: 04-10-2007, 07:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules