if u go to cheap option..see my 4th axis here;)
http://www.talkshopbot.com/forum/mes...tml?1227797954
if u go to cheap option..see my 4th axis here;)
http://www.talkshopbot.com/forum/mes...tml?1227797954
This is what Santa brought me in my indexer package.
36922.jpg
I apologize for the crappy picture but the SB image NAZIs wanted it that way.
That's a PRT/PRS Standard indexer, judging from the Wago cable end. Are you sure that you only have 4 drivers in the control box?
You DO have a PRS Standard, don't you? (You never clarified this crucial piece of info)
-B
Naive Question:
What am I missing? with any other CNC equipment three controllers are needed to drive three axes, four controllers for four axes, etc... why does the shopbot need a 5th controller to drive the 4th axis? Expanding on that, is there maybe a 4th driver in the PRS box as standard equipment in case someone wants to go to a 4th axis (i.e. indexer)? My experience has been a bit more with mills and lathes but I can't see why there would be a difference???
Gerald,
The X axis uses 2 controllers.
One for each side.
Ah, that explains it. My buddy only uses one so I was seeing it from that perspective.
Thanks much,
Gerry
DOH! Yes its a PRS Standard.
Joe--
Just like you're describing, my PRS standard was accidentally shipped without the 5th controller (Summer 2007). I called ShopBot and they sent me the missing component.