Hey guys... Im kinda at a loss... I just used my BOT the other day and it went home after it was done cutting and everything was cool. Today I went to move my Y axis out of the way and I can't get it to move. I unplugged the motor from the X axis and swapped them and the motor seems to be fine. I did notice with the motor laying on the table that it is trying to move a little bit. I checked the wiring at the connectors and they seem to be ok. There does seem to be kind of a snap of electricity when plugged in though..... Hope you guys can help I have a project I am suppose to have finished up by Thursday!!! Thanks for any help you can offer. Chris.