its totally a new table with a base and kind book space in between... and just for you jack..enjoy...
I'm beginning to think you take my "suggestions" as "challenges" and come up with something cooler then the previous one each time.
I liked the spinning top video but what you should do is carve the face of a roulette wheel or like the "wheel of fortune" and have it spin...
I had bought a "lazy susan" ball bearing wheel and it sounds kind of like thats what you had under your table? How did you mount that?
ANOTHER good project! You should start selling those tables like at craft shows and such.
I don't remember if i asked previously but what are you cutting them out of..plywood, glued up boards? How do your two different levels mount together?
I would think a roulette wheel would have better bearings in it..was going to make a aztec roulette wheel...that would fall apart in december..lol
all the tables are made from laminated pine..or denim pine as they like to call it...bugkilled pine...
I dont go to - or sell at craft fairs...not my thing...I have a spot in Winsor Plywoods stores..and online..the small step table has doweling 1/2 inch pins in it. am still waiting for you to post your go at it..
Would you please send me the files?
Could I please get a copy of your files. Thanks
Desktop Max with spindle, Vac, indexer, Aspire
Trotec Speedy 300 80W
AirWolf AW3D HD2x Printer
need a address to send to.???
Its done.... wont send anymore...
Desk/table..entry..whatever...a little bigger same design...they are going over very well...
This looks taller then your last one, i think that was more coffee table height? I liked that one and this looks like just a taller version of the same. I like it very much too!
You need to start embellishing the tops of these tables although that might be overdoing it. Regardless you have a good thing going there buddy!
I left woodwork due to office work.