PR96 V2 - Emergency Stop Button

[matic_media]

Can anyone tell me where to fit the emergency stop button on the above machine? Also could anyone email me the set up instructions for a V2 type board?

Thanks in advance.

Richard

[khaos]

This is a personal preference. Some people carry it around some people mount it by the pc ..

HTH,

[jerry_stanek]

I mounted mine ta the end of the table away from the control computer with the thinking that if I am at the computer end I can stop with the enter or space bar but if I'm at the other end I would have to run to the e stop or computer to stop it. As of now I have 2 E stops on my machine.

[jdervin]

I made the same choice as Jerry Stanek. Also, since my Bot is used by students, I made an oversized and over-obvious mounting plate for it. Photos and other people's solutions can be found here...

http://www.talkshopbot.com/forum/sho...1940#POST81940

[jamesgilliam]

Mine is also on the end of the machine on the opposite side from the control computer, but on the closest end to my office door into the shop. Since I don't stay at the machine all the time it was the most logical spot.

[jerry_stanek]

I am thinking of putting another one at my design computer so I don't have to run to shut the bot down when I'm in the office and something goes wrong.