Results 1 to 2 of 2

Thread: custom files

  1. #1
    Join Date
    Dec 2007
    Posts
    2,383

    Default custom files

    I made a little program to offset a cross hair laser how do I make it a custom file like the c2 or c3

  2. #2
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,845

    Default

    Easiest way is to go to 'Cuts/set up custom cut' in SB3 and paste your code in the middle clear section, put a name at the top as stated in the instructions and then Save as with a number of a open slot. Be careful what one you choose so that you don't over write one that you or SB uses.

    Close SB3 and restart it, and it should show in the list unless it's a high number, then it may not be on the list, but you can still call it up with CN and the number that you saved it as. Example, Custom13.sbc would be CN13.

    You can also just open one of the customXX.sbc files, cut and paste your code, change the description and save as to another number.
    Scott




Similar Threads

  1. Conversion of ArtCam files to eps files
    By gary_n in forum ShopBotter Message Board
    Replies: 1
    Last Post: 02-16-2016, 11:50 AM
  2. convert Excel 2007 files to .sbp files
    By roy_shimp in forum Troubleshooting
    Replies: 1
    Last Post: 05-12-2011, 01:56 PM
  3. Help creating custom files for xy zero with laser
    By airroots in forum ShopBot Control Software v3
    Replies: 5
    Last Post: 04-02-2011, 11:02 PM
  4. Custom Cut Files
    By nat_wheatley in forum Cabinetry and eCabinet/ShopBot Link
    Replies: 0
    Last Post: 06-15-2009, 09:07 PM
  5. Replies: 0
    Last Post: 03-19-2006, 02:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •