Results 1 to 3 of 3

Thread: angled plane for guitar

  1. #1
    Join Date
    Mar 2004
    Location
    RC CNC, Roberts Creek BC
    Posts
    270

    Angry angled plane for guitar

    I'm trying to create an angled plane on a guitar.
    The area in black is were the angled plane is
    The curved black line in the half circle is where the taper starts and tapers down .75 to the middle of the straight part of the half circle.
    I did this 4years ago but can't remember how I did it
    I've tried the angle plane but am not getting the results I'm looking for

    Brian
    Attached Images Attached Images

  2. #2
    Join Date
    Jan 2004
    Location
    iBILD Solutions - Southern NJ
    Posts
    6,830

    Default

    Try a 2-rail sweep with your desired angled cross section 'up on a chair' to get the correct Z height. Your rails will be each half of the outlined black area.

    -B
    High Definition 3D Laser Scanning Services - Advanced ShopBot CNC Training and Consultation - IBILD.com

  3. #3
    Join Date
    Mar 2004
    Location
    RC CNC, Roberts Creek BC
    Posts
    270

    Default

    Thanks Brady
    I'll try to remember it this time

    Brian

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •