I'm still getting acquainted with my setup, so I'm hoping this rather embarrassingly simple question will be easily answered.
I'm trying to cut a circle 2-3/8" in diameter, but I keep getting 2-1/4" circles instead (it's only being cut 1/4" deep).
I created the vector (2.375" diameter) & toolpath with AC2008 then saved the SBP file using 'Arc Inches'. The toolpath settings are:
2D profiling
Profile side: Inside
Final pass thickness: 0.1
Final pass allowance: 0.05
Profiling tool: 1/2" straight
Cut direction: Climb
Lead In/Out Moves: Distance 0.2, Overcut 0.2, Circular arc Radius 0.25
I haven't tried cutting these circles with SB3. All of the straight toolpaths I have created recently in AC have been accurate. Can anyone see anything wrong with this?